en:3d_export
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:3d_export [2023/06/02 15:43] – [Panel Print Preprocessing] onyxadmin | en:3d_export [2024/04/19 07:11] (current) – onyxadmin | ||
---|---|---|---|
Line 88: | Line 88: | ||
\\ | \\ | ||
- | {{: | + | {{: |
---- | ---- | ||
Line 119: | Line 119: | ||
{{: | {{: | ||
- | The object position is taken over from the object orientation in the 3d object library. Trim planes will not influence the position of the 3D object in relation to the model. | + | The object position is taken over from the object orientation in the 3d object library. Trim planes will not influence the position of the 3D object in relation to the model. See example [[add_pins|Add Occlusal Pins]]. |
---- | ---- | ||
====Option 7: Adapter 3D Print==== | ====Option 7: Adapter 3D Print==== | ||
Line 163: | Line 163: | ||
Several such export examples are described below.\\ | Several such export examples are described below.\\ | ||
Presetting a maximum [File Size] will reduce the final object file size by summarizing triangles in plane surface regions w/o influencing the geometrical object resolution.\\ | Presetting a maximum [File Size] will reduce the final object file size by summarizing triangles in plane surface regions w/o influencing the geometrical object resolution.\\ | ||
+ | |||
+ | **Please note** that most of the print preprocessing options refer to a reference plane. This must be defined and applied in [[# | ||
+ | |||
If print preprocessing is applied, all export processes run parallel as separate processes side by side - e.g. in serial export from module [[aligner_3d|Aligner 3D]]. | If print preprocessing is applied, all export processes run parallel as separate processes side by side - e.g. in serial export from module [[aligner_3d|Aligner 3D]]. | ||
Line 179: | Line 182: | ||
---- | ---- | ||
- | As of releases 3.2.169, | + | As of releases 3.2.169, |
{{: | {{: | ||
- | As of releases 3.2.185, the export option | + | As of releases 3.2.185, the perforation |
{{: | {{: | ||
Line 215: | Line 218: | ||
{{: | {{: | ||
- | ^ Hint ^ | + | <WRAP nicebox blue> |
- | | For manufacturing | + | For production |
+ | From 10/2023 until further notice please use option Print Preprocessing with 120% (without other parameters). | ||
+ | </ | ||
---- | ---- | ||
===== Links ===== | ===== Links ===== | ||
+ | |< 50% 10% >| | ||
|{{: | |{{: | ||
|{{: | |{{: | ||
+ | |||
+ | |< 50% 10% >| | ||
+ | |{{: | ||
+ | |||
+ | |< 50% 10% >| | ||
|{{: | |{{: | ||
- | |{{:pdf.png? | + | |{{:wiki_32.png? |
+ |
en/3d_export.1685713394.txt.gz · Last modified: 2023/06/02 15:43 by onyxadmin