Differences

This shows you the differences between two versions of the page.

--- en:3d_export [2024/04/19 07:10] – onyxadmin
+++ en:3d_export [2024/04/19 07:11] (current) – onyxadmin
@@ Line 164: / Line 164: @@
 Presetting a maximum [File Size] will reduce the final object file size by summarizing triangles in plane surface regions w/o influencing the geometrical object resolution.\\
-**Please note** that most of the print preprocessing options refer to a reference plane. This must be defined and applied in [[#panel_trim|panel Trim]] (e.g. cut planes top and bottom). In addition, this export alignment must be set to these trim planes in the same panel (e.g. selection [Upper/Lower]).
+**Please note** that most of the print preprocessing options refer to a reference plane. This must be defined and applied in [[#panel_trim|panel Trim]] (e.g. planes Up and Down). In addition, this export alignment must be set to these trim planes in the same panel (e.g. selection [Upper/Lower]).
 If print preprocessing is applied, all export processes run parallel as separate processes side by side - e.g. in serial export from  module [[aligner_3d|Aligner 3D]].