Differences

This shows you the differences between two versions of the page.

--- en:bracketlib_requirements [2023/07/22 15:12] – onyxadmin
+++ en:bracketlib_requirements [2024/04/10 13:41] (current) – onyxadmin
@@ Line 1: / Line 1: @@
-======Requirements bracket file import======
+======Requirements Bracket File Import======
 ----
+{{:0544_onyx_bracket_lib.png?56|Bracket Library}}
-The CAD files should be in STL, topologically correct (especially regarding closed meshes), __not larger than about 500kB__ per file.\\
+The CAD files should be in STL, topologically correct (especially regarding closed meshes), <wrap hi>**not larger than about 500kB**</wrap> per file.\\
 Clips of self ligating brackets should be closed. Structured bases should be avoided - use plain bases instead.\\
 We also need a table that specifies the following parameters for each file:
@@ Line 22: / Line 23: @@
 ----
 //Note://\\
-Scan files cannot be used.
+<wrap hi>**Scan files cannot be used**</wrap> unless the brackets have been reconstructed based on the scan.
+\\