Differences

This shows you the differences between two versions of the page.

--- en:3d_export [2023/06/02 15:44] – [Panel Print Preprocessing] onyxadmin
+++ en:3d_export [2024/04/19 07:11] (current) – onyxadmin
@@ Line 88: / Line 88: @@
 \\
-{{:export07ao.png?|}}
+{{:export07ao.png?&nolink|}}
 ----
@@ Line 119: / Line 119: @@
 {{:export07bo_a3do.png?650&direct|}}
-The object position is taken over from the object orientation in the 3d object library. Trim planes will not influence the position of the 3D object in relation to the model.
+The object position is taken over from the object orientation in the 3d object library. Trim planes will not influence the position of the 3D object in relation to the model. See example [[add_pins|Add Occlusal Pins]].
 ----
 ====Option 7: Adapter 3D Print====
@@ Line 163: / Line 163: @@
 Several such export examples are described below.\\
 Presetting a maximum [File Size] will reduce the final object file size by summarizing triangles in plane surface regions w/o influencing the geometrical object resolution.\\
+**Please note** that most of the print preprocessing options refer to a reference plane. This must be defined and applied in [[#panel_trim|panel Trim]] (e.g. planes Up and Down). In addition, this export alignment must be set to these trim planes in the same panel (e.g. selection [Upper/Lower]).
 If print preprocessing is applied, all export processes run parallel as separate processes side by side - e.g. in serial export from  module [[aligner_3d|Aligner 3D]].
@@ Line 215: / Line 218: @@
 {{:contactsurface.png|}}
-^ Hint  ^
+<WRAP nicebox blue>
-| For manufacturing by service provider Dreve, a flat contact surface design is required by default.   |
+For production by service provider Dreve, such a flat contact surface is required.\\
+From 10/2023 until further notice please use option Print Preprocessing with 120% (without other parameters).
+</WRAP>
 ----
 ===== Links =====
+|<  50% 10%  >|
 |{{:movie.png?20 |}} |[[https://www.youtube.com/watch?v=FnfhWhLD53E|Printing hollow]]  |
 |{{:movie.png?20 |}}           |[[https://youtu.be/IiExvsqdLHs|youtube|Tutorial Aligner Step Export]]  |
+|<  50% 10%  >|
+|{{:pdf.png?20|}}|[[https://doku.onyxceph.com/Quick guide_production_order.pdf|Export to Dreve]]      |
+|<  50% 10%  >|
 |{{:wiki_32.png?20|}}|[[simple3dexport|Easy 3D Model Export in Occlusion]]  |
-|{{:pdf.png?20|}}|[[https://doku.onyxceph.com/Quick guide_production_order.pdf|Export to Dreve]]      |
+|{{:wiki_32.png?20|}}|[[expl_printplate|Export Example Parallel Print Plate (rear)]]  |