[OnyxCeph³™ Wiki]

DokuWiki - World Wide Web

User Tools

Site Tools


en:dtat2107

09/2021

OnyxCeph³™ Release News


Even though customer contacts in the past 16 months had to be largely limited to telephone calls, e-mails and online meetings for well-known reasons, this did not stop us from the further development of the OnyxCeph³™ software, which is largely driven by user requests. Below are some comments on current topics that have been and are being worked on in this context:

Import Interfaces

1 2 3 Due to the increasing use of intraoral scanners, there is an increased interest in direct and easy to configure interfaces for scan import. To meet these requirements, several new interface options (for iTero, medit, CS3X00 and Trios, among others) have been implemented in recent months. For the portals MyiTero and MeditLink these interfaces can already be used in the current Softwarerelease 3.2.157.

Module Retainer

1 Starting with the upcoming release, there will be a direct interface for the retainer bending machine YOAT Bender 1 in the Retainer 3D module and a corresponding extension to the virtual round wire design.



Module Digitize 2D

Also available in the upcoming release will be an option to send cephalometric side images in the Evaluation module to the CellmatiQ service portal for AI-based retrieval and adoption of cephalometric fiducial locations in the image.



Module Segmentation

1 The Segmentation module has been fundamentally and now makes it possible to identify, separate and complete individual teeth even more reliably and quickly. It is now also possible to readjust crown segments after they have already been completed. These features can already be tested in the current version via activation and will be available as standard from the next release.



Module Aligner 3D

1 2 In the Aligner module, the Attachments and Timeline panels were visually and functionally revised. In addition, enhancements were made with regard to the options for automated trimming and labeling of aligner series, which are increasingly requested by service providers and hardware manufacturers, as well as production-oriented further processing after serial export.



Module V.T.O.3D

1 2 More features have also been added to the Virtual Setup planning module. This includes the new functions for accepting interpolated intermediate situations as treatment targets and the mandibular movement table.



Module FA_Bonding

1 Since the user must always consider the desired target alignment of the relevant crown in the dental arch when placing brackets relative to the actual situation, additional numerical and visual control options have been implemented in the module FA_Bonding to make it easier to find and evaluate the optimal position.



Module Bonding Trays 3D

1 In collaboration with 3M™, a new Digital-IBT design option specifically applicable to APC™ Flash-Free™ Brackets was developed, integrated and tested in the Bonding Trays Module. Additionally, the initialization of the inner trim line has been improved and endpoints for the last bracket crown have been added to ensure homogeneous stiffness of the IBT.



Visualization

Finally, new OpenGL shaders have been developed to, among other things, render textured tooth and soft tissue surfaces more realistically and optimize view options such as highlight, brightness, and blur based on the situation (see screenshots for modules Retainer 3D, FA_Bonding and Bonding Trays above on this page).


This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies
en/dtat2107.txt · Last modified: 2021/10/25 09:15 by onyxadmin