Differences

This shows you the differences between two versions of the page.

--- en:aligner_staging_2 [2022/09/19 11:22] – tom
+++ en:aligner_staging_2 [2024/03/05 07:47] (current) – onyxadmin
@@ Line 2: / Line 2: @@
 ----
-<WRAP center round todo 60%>
+<WRAP center round todo 75%>
 This functionality is still in development and only available as preview version for testing. Please verify all results and models exported from the planning as usual.
 </WRAP>
@@ Line 9: / Line 9: @@
 The following description explains concepts and interactions on a simple example with a single tooth (expand the items by clicking them):
+++++ - Tooth movement limits: Step 1 <-> Step N |
+A warning is shown when the window is opened with different movements limits for step 1 and all other steps. A specific value for the first step is not relevant for movements which are started later and such a setting would also make some measurement values harder to understand. Open the protocol "Limits of tooth movement" and set the same values for both sides.
+++++
 ++++ - Linearly continuous movements represented as single bars |
@@ Line 34: / Line 40: @@
 {{:5620_staging4.png?nolink|}}
   * Double-clicking a movement on a step will split the movement there
-  * A dialog allows to select a different speed / proportion using the limit values
+  * A dialog allows to select a different speed / proportion using the limit values (if they are displayed)
 ++++
@@ Line 61: / Line 67: @@
 {{:5620_staging9.png?nolink|}}
-  * If a single component is visualized, the movement value is shown instead of the limit factor
+  * Similar to the 3D object list, the checkbox controls the visibility while the selection (multiselect with Ctrl) controls which components are manipulated
-  * Movements can still be split by double-click, but changing position of the whole movement is currently not available
+  * Movements can still be split or merged by double-click
-  * Combined visualization shows components proportional to limit values (needs limit values)
 {{:5620_staging10.png?nolink|}}
-  * Component values can be shifted from one movement to another (Icon ->)
+  * Component values can be shifted from one movement to another using the arrows from the toolbar
   * Holding the Ctrl-key allows to set a specific value remaining on the left side in percent, mm/° or limit factor (''50% 1mm 2x'')
 ++++
@@ Line 80: / Line 85: @@
   * (right) Optimize speed by double-clicking the single parts so that only 10 steps are required (2+3+2+3)
 ++++
+|{{en:onyx_patch.png?20}}    | [[https://doku.onyxceph.com/AlignerStaging.O3P|Patch for activation on any computer]]  |