Differences

This shows you the differences between two versions of the page.

--- en:3531 [2015/10/27 12:38] – onyxadmin
+++ en:3531 [2015/10/27 12:38] (current) – [#3531 Adjust Cutting Line] onyxadmin
@@ Line 2: / Line 2: @@
 ===== #3531 Adjust Cutting Line =====
 ----
-For Releases > 3.2.35 in Modul [[base_tray|Cast Adjust]] the polyline which is used to clip/cut the scan data to add a standard base tray can be adjusted afterwards. For this purpose, the node to be moved has to be selected again and then placed by a rightmouse click onto its new position. Also in case the line was closed already (green line) by [CTRL]+Z the edit mode can be reopened.\\
+For Releases > 3.2.35 in Modul [[base_tray|Cast Adjust]] the polyline which is used to clip/cut the scan data to add a standard base tray can be adjusted afterwards. For this purpose, the node to be moved has to be selected again and then placed by a rightmouse click onto its new position. Also in case the line was closed already (green line), by [CTRL]+Z the edit mode can be reopened.\\
 \\