en:3429
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:3429 [2015/10/25 21:44] – onyxadmin | en:3429 [2015/10/26 08:29] (current) – [#3429 Aligner_3D: Option Scan Refinement] onyxadmin | ||
---|---|---|---|
Line 3: | Line 3: | ||
---- | ---- | ||
- | Since release 3.2.7 (77) in module Aligner_3D, an additional panel is available bottom down in the module window middle panel which has 3 separate buttons. The functionality linked to this panel can be used to adjust a calculated aligner step by the actual treatment situation using an intermediate scan to refine the current step and therefore, the subsequent planning. | + | Since release 3.2.7 (77) in module Aligner_3D, an additional panel is available bottom down in the module window middle panel which has 3 separate buttons. The functionality linked to this panel can be used to adjust a calculated aligner step by the actual treatment situation using an intermediate scan to refine the current step and therefore, the subsequent planning.\\ |
- | + | ||
- | {{: | + | |
- | + | ||
- | The intermediate scan has to be imported as a model finding as usual. It should be aligned as identical as possible like the malocclusion scan which originally was used for the alinger planning project.\\ | + | |
- | + | ||
- | By button [Load] the intermediate scan is imported to the Aligner_3D module, overlayed and aligned by common surface features which have not been influenced by the treatment so far.\\ | + | |
\\ | \\ | ||
- | By button | + | [[panel_scanrefinement|{{: |
- | \\ | + | |
- | By button | + | |
- | + |
en/3429.1445805870.txt.gz · Last modified: 2015/10/25 21:44 by onyxadmin